Manufacturing
Part Surface Area Calculator
Work out the total surface area of a part for plating, anodizing, powder coating or painting: every face, edge and hole wall, for one part or the whole lot, with the cost at your price per ft².
Part surface area
Total surface area of plate, bar, tube, angle and hex parts with holes, and the plating or coating cost of a lot.
Work out the weight and total surface area of plate, flat bar and round bar in steel, stainless, aluminum, brass, copper and plastic, for quoting material, shipping and coating.
Free to use, no signup needed. Calculations run in your browser.
How to calculate a part’s surface area for plating and coating
Platers, anodizers, powder coaters and painters price by surface area, so the area you quote on decides whether the job makes money. Total surface area is every face that gets coated: both sides, every edge and end, and the wall of every hole.
For a plate it is 2 × (length × width) for the faces plus the perimeter × thickness for the edges. A through hole takes away its two round openings but adds its wall, π × diameter × thickness, so small holes in thick plate add area rather than remove it. Tubes have an inside wall too, which counts if it gets coated.
Worked example: 100 steel brackets, 12 × 6 × 1/4 in, four 1/4 in holes, zinc plated at $1.10 / ft²
- Faces and edges:
- 153.00 in²
- Four holes (walls minus openings):
- +0.39 in²
- Area per bracket:
- 153.39 in² (1.065 ft²)
- Area for 100:
- 106.52 ft²
- Plating at $1.10 / ft²:
- $117.17
With a $45 minimum lot charge, an order of 5 brackets (5.3 ft², $5.86 by area) is billed at the $45 minimum: $9.00 a part.
- Leaving out the edges is the most common mistake: on 1/4 in plate they are 6% of the area, on 1 in plate far more.
- Racking, masking and parts per tank or barrel change the price per part as much as the area does, which is why small lots need a minimum charge.
- For real parts with pockets, slots and bends, take the area from the CAD file rather than estimating from the print.
Common questions
- How do you calculate the surface area of a part for plating?
- Add up every face that gets plated: for a plate, 2 × length × width plus the perimeter × thickness, then add the wall of each hole (π × diameter × thickness) and take off its two openings. Divide square inches by 144 for square feet.
- Do holes increase or decrease surface area?
- A through hole removes two circular openings but adds its cylindrical wall. When the hole’s diameter is less than twice the plate’s thickness, the wall is bigger, so the part gains area.
- How is plating priced?
- Most shops price by area (per ft² or m²) or by the load, with a minimum lot charge so small orders still cover setup, racking and tank time.
Calculators in Manufacturing
- Metal weight & surface area — Weight and total surface area of a plate or round bar in common metals and plastics.
- Part surface area — Total surface area of plate, bar, tube, angle and hex parts with holes, and the plating or coating cost of a lot.